Etched heating element - flexible - high thermally resistant - 1,0 mm thin - serial production
Heating element type FS250X
raw materials:
base:     Etched metal foil
insulation:  fabric-reinforced silicone rubber, hot-vulcanized
connection: soldered wires with waterproof cover cap
technical data:
max. dimensions:  250 x 380 mm
thickness: 1,0 mm (except cover cap)
max. temperature: 250 °C
max. specific heating power: 0,95 W/ cm²
voltage: 12 - 230 V
possible extra features:
  • uniform or non-uniform heating over the area
Thin film heating up to 250 °C, special geometries, for liquids and in medicine technique, uniform or if requested non-uniform heat production.
Preferably for higher quantities (serial production), as the initial costs are relatively high. (lay-out, etching mask)
Applicable under dry conditions for small installation highs.