Etched heating element - flexible - 0,8 mm thin - serial production
Heating element type F80X
raw materials:
technical data:
possible extra features:
Thin film heating up to 80 °C, special geometries, uniform or if requested non-uniform heat production.
Preferably for higher quatities (serial production), as the initial costs are relatively high. (layout, etching mask)
Applicable under dry conditions for small installation highs.
base: | etched metal foil |
insulation: | polyester/polyethylene compound foil, hot-sealed or polyester foil with adhesive layer |
connection: | double-rivets (soldered or AMP-connector) |
max. dimensions: | 250 x 800 mm (circle: 250 mm D) |
max. temperature: | 80 °C |
max. specific heating power: | 0,17 W/ cm² |
voltage: | 6 - 48 V |
possible extra features:
- self adhesive (one side or both sides)
- thermostat glued on the element as limitor
- uniform or non-uniform heating over the area
- deviding into two heating circuits possible (low / high power)
Thin film heating up to 80 °C, special geometries, uniform or if requested non-uniform heat production.
Preferably for higher quatities (serial production), as the initial costs are relatively high. (layout, etching mask)
Applicable under dry conditions for small installation highs.